Here is a look at the inside:

You can see that there are panels covering the top and bottom of the card. This is attaching the top and bottom of the lattice die to the card which then holds the pop out in the center…

I had to score this one to get it to fit in the card.
You can kind of see how the lattice works here:

I cut the lattice die in half, and scored it at every intersection… then glued the end pieces behind the panels and left the center to fold out…

Lattice die, that I cut in half…

and scored.

I glued the ends to the panels that hold them to the card (3×2.25)

So, this is what the final inside panel looks like. Then, you glue the ends of the black panels to the card (top and bottom) and you get this…

This is what you stick the pop up on. And, you can use this for ANYTHING. Not just Halloween. What a fun surprise!!
AND, when I was making these, I received my envelope board. So, I had to make matching envelopes. Though these are 3×3 cards, I decided to make envies for 3.5 cards (which is a little big) because I was worried that the thickness of the card would not let the card fit into the envelope.
One last look:

No comments:
Post a Comment